If the CE marking is reduced or enlarged the proportions given in the above drawing must be respected.
The various components of the CE marking must have substantially the same vertical dimension, which may not be less than 5 mm. This minimum dimension may be waived for small-scale safety components.
The CE marking shall be followed by the identification number of the notified body that deals with
- the procedures referred to in Article 8 (1) (a) (ii) or (iii),
- the procedures referred to in Article 8 (2).
§ 138 CE marking
The requirements for the CE marking described in Annex III are set out in Article 10 of the Lifts Directive - see comments on Article 10.
§ 139 CE-marking for lifts
The CE marking for lifts must be affixed in the lift car, together with the other markings required - see comments on section 5.1 of Annex I.
The European Coordination of Notified Body has made a recommendation, endorsed by the Lifts Working Group, to clarify the identification number of the Notified Body that shall follow the CE marking of a lift according to the last paragraph of Annex III - see NB-L REC 2/004
The identification number of the Notified Body to follow the CE-marking of lifts is as follows:
|
Conformity assessment procedure according to Article 8 (2), paragraph: |
Identification number of the Notified Body that carried out the: |
| (i), (ii) or (iii) |
Final
inspection
(Annex
VI) or Approval of the quality assurance system (Annex XII, XIII or XIV) |
| (iv) | Unit verification (Annex X) |
| (v) | Approval of the full quality assurance system (Annex XIII) |
§ 140 CE-marking for safety components
Article 10(2) requires that the CE marking shall be affixed on each of the safety component listed in Annex IV, or, where that is not possible, on a label inseparably attached to the component.
The identification number of the Notified Body to follow the CE-marking of safety components is as follows:
|
Conformity assessment procedure according to Article 8 (1) (a), paragraph: |
Identification number of the Notified Body that carried out the: |
| (i) | - |
| (ii) | Approval of the quality assurance system (Annex VIII) |
| (iii) | Approval of the full quality assurance system (Annex IV) |
